£178.52

The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay:

  • if the charge disconnect output of the VE.Bus BMS is high, and
  • if it senses 13,7 V (resp. 27,4 V or 54,8 V) or more on its battery charger connection terminal, and
  • if it senses 2 V or more on its battery terminal (the Cyrix will remain open if not connect to the battery).

The Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature.

In general a cell over voltage alarm will reset shortly after charging has been stopped. The Cyrix will then reconnect the charger after a delay 3 seconds. After 2 attempts to reengage with 3 seconds delay, the delay increases to 10 minutes. Whenever battery voltage is less than 13,5 V (resp. 27 V or 54 V), the Cyrix will disengage with a delay of 1 hour. Note 1: In case of zero discharge current, or a small discharge current, the Cyrix will not disengage shortly after the charger has been switched off and/or disconnected, because battery voltage will remain higher than 13,5 V. Note 2: If, after the Cyrix has disengaged, the output of the battery charger immediately increases to 13,7 V or more, the Cyrix will reengage, with 3 seconds delay.

Brand

Victron Energy

Manufacturer Part Number

CYR020230430

Voltage

24/48

Continuous current & Breaking capacity at 12V or 24V

230A

Current Consumption When Open

4 mA

Control Cable Included (Length 1 m)

Yes

LED Status Indication

Yes

Protection Category

IP54

Dimensions

H65 x W100 x D50mm

Weight (kg)

0.27

Warranty

5 Years

Country of Manufacture

Malaysia

My Cart
Wishlist
Categories